Arming; Open Circuit Bypass; Central Locking - Mongoose M80i User's Operation Manual

ARMING

NORMAL OPERATION

Exit the vehicle and ensure all doors, bonnet & boot are closed.

Press remote button one for approximately 1 second (2+ seconds if turbo timer on).
To confirm arming, the indicators flash once, the siren chirps once and the dashboard
warning LED, will then slow flash.

If your vehicle has central locking and it has been connected to this security system, the
doors will lock at the same time as arming.
If the automatic engine immobiliser has activated before you wished to arm the system, press
button one twice – once to disengage the immobiliser and a second time to fully arm (and lock the
doors if connected) and immobilise the system. Note: The system can be programmed to arm
automatically 30 seconds after the last door is closed. See page 12.

OPEN CIRCUIT BYPASS

If any door, the bonnet or boot is left open when you arm the system, the siren will chirp once to
signify the system is armed and then chirp again to inform you a circuit is still open. The dash
mounted LED will flash a code for 30 seconds showing you what is open (see page 10). If ignored
and not closed, that circuit will not be protected. The open circuit will automatically arm upon
closure.
CENTRAL LOCKING - additional parts, at extra cost, may be required.
This security system has built-in relays to operate a vehicles' existing central locking system by remote
control. When connected, the doors will lock or unlock at the same time as arming or disarming.
SILENT ARM (no siren chirps)
Press button two and then, within 2 seconds, button one to silently arm the system.
The chirps may be permanently turned off via the programming options – see your installer.
5