Ignition Switch - Plymouth Gran Fury 1980 Operating Instructions And Product Information

mended SAE viscosity grades are show n on page 49. NON-
DETERGENT OR STRAIGHT MINERAL OILS MUST NEVER BE
USED.
Frequently, a new engine will consume some oil during its first
few thousand miles of operation. This should be considered as a
normal part of the break-in and not interpreted as an indication of
difficulty.
Ignition and Steering Lock
The key can be inserted or withdrawn only in the LOCK p osition.
ACCESSORY-Allows operation of
electrical accessories with engine
off.
LOCK-Locks steering & ignition .
OFF-Engine off . Steering not
locked .
ON-Key returns to ON after engine
is started .
START-Start engine and release
key.
LOCK
\
Note : If your car has a column mounted gear selector, the key
cannot be t urned to LOCK until the selector is in the PARK
position .
Do not attempt to pull the shift lever o ut of PARK after the key is
in th e LOCK position.
Ignition Switch Lamp (If so equipped)
The switch is lighted w hen the driver's door is op ened. The lamp
w ill remain on for approximately 20 seconds after door is closed to
facilitate inserting the key.
Key-in-Lock Reminder
If the driver's door is opened when the key is in the ignition lock,
an intermittent bee ping will remind you to re move the key.
Illuminated Entry System (optional)
Each exterior door lock cylinder is illuminated and the interior
dome/co urtesy lights go on when either front door handle is
lifted.
The lights will go off after approximately 30 seconds, or when the
ignition switch is turned to the ON position.
3