Check List; Further Information 13 - Shoprider Traveso 889XLSBN/CAN User Manual

Continued.....

Check List

If you scooter fails to operate, please check the following:
 The unit is switched on.
 All plugs and connectors are firmly fixed.
 Battery level shows full charge.
 Freewheeling device is in the drive position (lever down).
 Circuit breaker has not tripped
If the freewheel device has been operated with the scooter left switched on,
the scooter will bleep continually and not operate until the ignition key has
been switched off then on again.
Please consult your dealer if your scooter does not run after checking these
points.
Further Information
Safety Information Regarding Electromagnetic Interference (EMI)
Scooters and powerchairs are designed to operate under certain conditions.
However, radio waves or electromagnetic fields may affect the operation of
the scooter. The source of EMI could be radio or television transmitters or
portable devices such as mobile phones, portable CB radios etc.
Should any unintentional movement occur turn the scooter off as soon as
safely possible.
Solar Energy
During periods of sunny weather, it is possible that surfaces of your scooter
may reach high temperatures (as with motor vehicles). Please take
precautions if leaving the scooter in direct sunlight for any period of time.
Seek shade or cover the seat and hand controls to keep any temperature
increases to a minimum.
Health Factors
Suitability for this product has been assessed on the user's current state of
health. It is essential that the user regularly monitor their ability to use the
scooter safely.
Please read and adhere to the guidelines set out in this manual and in the
'Code of practice for Class 3/C vehicle users'
Sleep Mode
Your scooter has a digital battery status indicator, which displays the current
charge status of the batteries in your scooter.
The circuitry also detects changes in power draw from the batteries.
If you scooter is left switched on without use for about five minutes the
electronics will go into 'sleep' mode to conserve power. You will see one bar
on the battery status indicator oscillate from side to side. Simply switching the
scooter off and back on will enable the scooter to operate as normal.
13