Jøtul F 262 Installation And Operating Instructions Manual page 9

Fig. 17
180°
A
1. Bend up the outer part (Fig. 17 A) of the bracket.
If rear smoke outlet:
Place the rear plate (Fig. 4 B) and mount it temporarily as
shown in figure 21.
Fig. 18
1. Carefully raise the soapstone side panel.
2. Adjust the position of the soapstone and tighten the screws.
3. Lift the soapstone panel and carefully lower it over the
bolts (Fig. 18 A).
4. Then push the upper section of the soapstone side panel
on to the burn chamber (Fig. 18 B).
Fig. 19
1.
2.
3.
Fig. 20
B
A
1.
A
Mount the soapstone side panel to the burn chamber
with the screws (Fig. 19 A and B).
If soapstone top: Replace the screws (Fig. 19 B) with the
bolts and nuts (Fig. 19 C) provided.
Mount the other soapstone side panel the same way.
Lift the rear plate (Fig. 20 A) and slide it down between
the soapstone side panels (Fig. 20 B).
ENGLISH
C
B
A
B
9