Jøtul F 262 Installation And Operating Instructions Manual page 8

ENGLISH
Fig. 11
A
1. Mount the pins (Fig. 11 A) and the clips (Fig. 11 B).
2. Join the two side panels together using a clip (Fig. 11 C).
3. If rear outlet: Mount an extra clip in the lower part of
the opening (Fig. 11 D).
Fig. 12
1. Mount the nuts from inside of the base.
Fig. 13
1. Place the top plate (Fig. 13 A), air grate (Fig. 13 B) and
bowl (Fig. 13 C).
8
C
B
D
C
B
A
If soapstone top:
Fig. 14
1. Replace the screws with bolt and nut (fig. 14 B) provided.
2. Place the soapstone top (Fig. 14 A) on the screws
(Fig. 14 B) and the guiding warts (Fig. 14 C).
3. Adjust the screws (Fig. 14 B) until the soapstone top is level.
4. Place the steel cover (Fig. 14 D).
Soapstone side panels
Important!
Bear in mind that the stones may be damaged if they are handled
roughly. Installation should be carried out by a qualified person.
With rear smoke outlet the rear plate has to be prepared
as shown in figure 4.
Fig. 15
C
B
1. Place 2 soapstones (Fig. 15 A) carefully on the floor.
2. Mount the bracket (Fig. 15 B) with 4 screws (Fig. 15 C).
Do not tighten the screws yet.
Fig. 16
A
3. Mount the next 2 soapstones (Fig. 16 A) to the bracket (Fig. 16
B) with 4 screws (Fig. 16 C). Do not tighten the screws yet.
D
A
C
B
A
C
B