Replacing Parts; Accessing Internal Computer Components - Compaq 5000 Series Hardware Manual

Replacing Parts

Your computer is
constructed with an Easy
Access panel. This design
makes accessing the
internal parts easy.
Failure to disconnect the
power from the computer
may result in personal injury.
Before working with the
components inside the
computer, you must ground
yourself and the equipment to
prevent static electricity from
damaging the parts. To
discharge any static buildup,
you should touch a metal part
of the computer chassis
before touching any internal
parts.
The screw(s) securing the
side access panel are for
shipping purposes only and
do not need to be replaced.
4
Replacing Parts

Accessing Internal Computer Components

Note: if you would like to replace the system board or microprocessor,
please contact the Compaq Technical Support Centre at the telephone
number listed in your warranty.
Your safety is important. Before performing any procedures involving the
components, take a few minutes to read the Warning and Caution
Statements in the Introduction chapter of the Getting Started and Beyond
Guide. Following the guidelines in these statements will help reduce the risk
of personal injury or equipment damage.
1. Turn off the computer
according to the instructions
provided in the Getting
Started and Beyond Guide.
2. Disconnect the power cable
from the wall socket and
computer.
3. Disconnect all peripheral
device cables from the computer.
4. Remove the screws securing
the side access panel.
5. Locate the latch directly
below the screw, pull down,
and hold in the down
position.
C H G
OMPAQ ARDWARE UIDE