High Power Operation; Timer Operation - Toshiba RAV-SM562XT-E Owner's Manual

HIGH POWER OPERATION

High power (High POWER)
• The High POWER (high power operation) mode automatically controls
room temperature, air flow and operation mode so that the room is quickly
cooled in summer and warmed in winter.
Setting High POWER mode
(1) High POWER button
Push the High POWER button. The High POWER lamp (green) on
the display panel of the indoor unit lights up. At the same time, the
"High POWER" mark on the remote controller is indicated.
Canceling High POWER mode
(1) High POWER button
Push the High POWER button once again.
The High POWER lamp on the display panel of the indoor unit
lights goes out.
At the same time, the "High POWER" mark on the remote
controller goes out.
CAUTION
The High POWER mode cannot be activated in the DRY and FAN ONLY
operation and when the ON TIMER operation is reserved.

TIMER OPERATION

ON timer and OFF timer
Setting TIMER
(1) ON/OFF TIMER button
Push the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and flashes along
with ON/OFF TIMER display.
(2) TIMER button
Push the TIMER
Set the timer to the desired time.
Each push of the TIMER button changes the time in ten minute steps.
Pushing the TIMER button continually changes the time in one hour steps.
(3) SET button
SET
Push the SET
SET
The timer time is indicated and the timer starts.
(4) CLR button
CLR
Push the CLR
CLR
CAUTION
• When you select the timer operation, the remote controller
automatically transmits the timer signal to the indoor unit at
the specified time. Therefore, keep the remote controller in a
location where it can transmit the signal to the indoor unit
properly.
• If you do not push the SET
setting the time, the setting will be cancelled.
Once you select the timer operation mode, the settings are saved in the remote controller.
Thereafter, the air conditioner will start operating under the same conditions when you simply push the ON/OFF
button of the remote controller.
If the clock display is flashing, you cannot set the timer.
Follow the instructions in the section "SETTING THE CLOCK" on page 6 to set the clock, and then set the timer.
button.
button to set the timer.
button to cancel the timer setting.
button within 30 seconds after
SET
(1)
(1)
(2)
(3)
(4)
10
A
PRESET
START/STOP
FAN MODE AUTO
ECO Hi-POWER
SWING
TIMER
FIX MEMO
ON OFF SET CLR
FILTER
RESET CLOCK CHECK
PRESET
START/STOP
FAN MODE AUTO
SWING ECO Hi-POWER
TIMER
FIX MEMO
ON OFF SET CLR
FILTER
RESET CLOCK CHECK