Table of Contents
Related Manuals for Whisper Power Belt Power W-BD 3.5
Summary of Contents for Whisper Power Belt Power W-BD 3.5
- Page 1 INSTALLATION MANUAL Belt Power belt driven generator W-BD 3.5 / W-BD 5: 230V 50Hz WHISPER POWER BV Kelvinlaan 82 9207 JB Drachten Netherlands Tel.: +31-512-571550 Fax.: +31-512-571599 V3.1 November 2011 V1 June 2010 www.whisperpower.eu...
-
Page 2: Table Of Contents
CONTENTS CONTENTS: INTRODUCTION ................................3 General ................................3 The application of belt driven generator ......................3 1.2.1 Belt driven generators ........................3 1.2.2 How does it work ..........................3 INSTALLATION ................................4 General ................................4 Location ................................4 Ventilation ................................4 Connections ................................ -
Page 3: Introduction
INTRODUCTION 1 INTRODUCTION GENERAL independently from a battery the installation is not as heavy as a battery-based inverter system and also more efficient, This installation manual applies to the installation of the because a fully battery based inverter system has a battery Belt-Power belt driven generators, first launched in June efficiency loss of at least 20% + a transformer loss of 10%. -
Page 4: Installation
2 INSTALLATION GENERAL Remote control An optional remote control is available and can be mounted To ensure reliability and durability of the equipment, it is on the dashboard of the vehicle/boat, or in another place very important that the installation is carried out with the from where one wants to operate the Belt-Power. - Page 5 INSTALLATION Fuse: W-BD 3,5 10 Amp. W-BD 5 12/15 Amp. Figure 1: general lay out of the system EN / W-BD3.5/W-BD5 BeltPower / October 2011...
-
Page 6: Low Voltage Dc Control System
INSTALLATION Remote control cable warnings and alarms. Refer to the users manual for a full When an optional remote control panel is in the delivery a 5 overview of all signals and displays for operation and for m connection cable will be included. A 10 m and a 15 m fault finding. -
Page 7: Connecting The Cables
INSTALLATION maintenance personal of garages that do Do not alter the shielded cable. Do not connect service on the vehicle. an extension to the shielded cable. Different cable lengths are available from your Whisper Generators used on vehicles that are operated Power dealer. - Page 8 INSTALLATION FUSE An output fuse (between the inverter set and the electrical installation) should be installed to protect the installed electrical system. The following maximum single phase output current applies: Model Maximum single phase output current W-BD 3.5 16 Amps W-BD 5 25 Amps The fuses must be of the slow reacting type.
-
Page 9: Installation Of The Generator
INSTALLATION When an automatich switch is preferred WhisperPower ATTENTION! recommends installation WhisperPower The W-BD5 model needs 6500 RPM to Systemswitch as the power source selector. This switch generate 5 kW. Compared with the W-BD3.5 the works automatically when the generator is off, the input 5 kW model will also need more RPM (3200) to remains in the land line position and as soon as the generate 1 kW. - Page 10 INSTALLATION SPEED/POWER DIAGRAMS Watt SPEED AND ELECTRIC OUTOUT POWER MEASURED FOR THE 3.5Kw MODEL AT 230V Watt SPEED AND ELECTRIC OUTOUT POWER MEASURED FOR THE 5Kw MODEL AT 230V W-BD 5 (5 kW) Figure 12: speed/power diagrams November 2011 / W-BD3.5/W-BD5 BeltPower / EN...
- Page 11 Mounting the generator on the engine Find a place on the engine where the generator can be mounted. The pulley of the generator should be aligned with the pulley on the crankshaft. For some car models there are standard brackets available to mount the generator.
- Page 12 INSTALLATION idler tensioner pulley. The idler tensioner pulley also Pulleys extends the contact area between V-belt and pulley. A poly V belt pulley with 6 groves and a diameter of 60 mm and an overhang of 5 mm. (refer to the figure 14).is When the generator is not connected to the engine block, recommended.
-
Page 13: Dimensional Drawings
2.10 DIMENSIONAL DRAWINGS Figure 17... - Page 14 DIMENSIONAL DRAWINGS Figure 18: dimensions inverter box W-BD3.5 and W-BD 5 November 2011 / W-BD3.5/W-BD5 BeltPower / EN...
- Page 15 DIMENSIONAL DRAWINGS Figure 19: dimensions remote control EN / W-BD3.5/W-BD5 BeltPower / October 2011...
- Page 16 Kelvinlaan 82, 9207 JB Drachten, The Netherlands www.whisperpower.com / sales@whisperpower.nl...