Control Modes; One Led Par 64; Auto Run); One Led Par 64 (Sound Control) - SHOWTEC LED PAR 64 SHORT Product Manual

Control Modes

One LED Par 64

(Built-in Programs, Auto
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the LED Par 64 is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 12 or 13 for more information about the built-in programs.
One LED Par 64 (Sound-control)
1.Plug the end of the electric mains power cord into a proper electric power supply socket.
2. Turn on the music. If device is set to
fixture will react to the beat of the music.
sound-control options.
Multiple LED Pars
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the LED Par 64.
The pins:
3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 12+13 (Built-in Programs,
Auto Run or Music control). This means on the master device you can set your desired
operation Mode and all slave devices will react the same as the master device.

(Master/Slave control)

1. Earth
2. Signal -
3. Signal +
Multiple LED Pars
Run)
(Audio) and you have pressed enter, then the
Please see page 12 for more information about the
(Master/Slave control)
7
Fig. 3