SHERCO 2012 SE 250i-R Shop Manual page 21

•
Install the camshaft retaining cover. (pay Install the camshaft retaining cover. (pay
careful attention to the tightening order). careful attention to the tightening order).
Camshaft retaining cover torque Camshaft retaining cover torque
10Nm
•
Install the camshaft chain tensioner Install the camshaft chain tensioner
using a new gasket.
Torque the two fixing bolts to: Torque the two fixing bolts to:
10Nm
•
Install the cam tensioner adjusting bolt Install the cam tensioner adjusting bolt
(pay attention to the o-ring).
Torque the tensioner adjusting screw to: Torque the tensioner adjusting screw to:
10Nm
•
Remove the special tool number 1819. Remove the special tool number 1819.
•
Rotate the engine a few times to make the engine a few times to make
sure that the valve timing is correct. sure that the valve timing is correct.
•
Finally check the valve timing using the Finally check the valve timing using the
timing marks.
•
Replace the cap that was removed to Replace the cap that was removed to
install tool number 1819.
Torque the cap to:
8Nm
•
Replace the spark plug well. Replace the spark plug well.
Make sure that the o-rings are installed on
the spark plug well.
rings are installed on
7
5
6
20/54
4 2
1 3