Table of Contents
Advertisement
Value
Value
Value
of
of
of
the
the
the
Check that the painting has not accidentally removed from the butterfly stop screw. Never touch
Check that the painting has not accidentally removed from the butterfly stop screw. Never touch
Check that the painting has not accidentally removed from the butterfly stop screw. Never touch
the butterfly stop screw.
The bike must be in perfect working condition (valves adjusted properly, fresh air filter, etc.).
The bike must be in perfect working condition (valves adjusted
Check that air by-pass air screw at the injector body is not unscrewed over two TURNS out
pass air screw at the injector body is not unscrewed over two TURNS out
pass air screw at the injector body is not unscrewed over two TURNS out
(factory
(factory
(factory
Make this adjustment with the engine running.
Make this adjustment with the engine running.
1- For this operation you must have a lambda probe and a gas analyzer.
For this operation you must have a lambda probe and a gas analyzer.
Do not exceed the range of -15 to +15. If you must get out of this range, there is a
problem (injector, TPS sensor, etc.).
2 – If you do not have a lambda probe and gas analyzer.
If you do not have a lambda probe and gas analyzer.
If your perfectly tuned bike has an unstable idle you can set it using the Trimmer function.
If your perfectly tuned bike has an unstable idle you can set it using the Trimmer function.
If your perfectly tuned bike has an unstable idle you can set it using the Trimmer function.
Do not exceed the range of -15 to +15. If you must get out of this range, there is a
problem (injector, TPS sensor, etc.).
lem (injector, TPS sensor, etc.).
butterfly
butterfly
butterfly
angle
angle
angle
value:
value:
value:
- Run the engine until it reaches 80 ° C.
Run the engine until it reaches 80 ° C.
- Connect the CO detector
Connect the CO detector
- Perform t
Perform the test in real conditions (saddle and air filter installed)
he test in real conditions (saddle and air filter installed)
- In the Configuration menu
Configuration menu, set the CO at 5%
15 to +15. If you must get out of this range, there is a
15 to +15. If you must get out of this range, there is a
ensor, etc.).
15 to +15. If you must get out of this range, there is a
15 to +15. If you must get out of this range, there is a
Idle speed : 2.5i : 2200 +/-100tr/min
Idle speed
position
position
position
should
should
should
1
1
1
be:
be:
be:
2.7
2.7
2.7
<3.1
<3.1
<3.1
properly, fresh air filter, etc.).
46/54
<3.5
<3.5
<3.5
round).
round).
round).
Hide quick links:
Advertisement
Table of Contents
