Error Codes; Protective Circuit - Tunturi GO 15 User Manual

ERROR CODES

The user interface will display
information about operational faults.
E1: Speed sensor error.
Unplug the electrical cord from the wall
outlet and from the treadmill, wait 1
minute and turn the power switch on
again. If treadmill recovers to normal
operation, you may continue to use the
treadmill. Otherwise, call the dealer for
service.
E6, E7: Lift motor error.
Unplug the electrical cord from the wall
outlet and from the treadmill, wait 1
minute and turn the power switch on
again. If treadmill recovers to normal
operation, you may continue to use
the treadmill.

PROTECTIVE CIRCUIT

The machine will shut off when the
electricity load is above the machine's
capacity. To restart the machine, please
follow the procedure below:
• Unplug the power cord from the
machine's socket.
• Push in the safety switch.
• Replug the power cord into the
machine's socket.
NOTE!
DON'T PUSH IN THE SAFETY
SWITCH BEFORE UNPLUGGING THE
MACHINE'S POWER CORD.
O W N E R ' S M A N U A L
If you leave the treadmill plugged in
after turning off the console, there will
still be current running to the console.
This treadmill is equipped with a safety
control program that will automatically
shut down the machine after six hours of
no use. In the event of an automatic shut
down, please follow the procedure below
to restart the treadmill: A. Unplug the
power cord form the machine's socket.
Replug the power cord cord into the
machine's socket to restart the machine.
GB
•
G O R U N 1 5
11