Adjusting The Belt Tension; Malfunctions; Error Codes; Protective Circuit - Tunturi GO 10 User Manual

edges of the belt may be damaged
and the treadmill may not continue to
operate correctly. Any damage to the
belt caused by the lack of necessary
adjustment will not be covered by the
warranty.

ADJUSTING THE BELT TENSION

The belt must be tensioned if it begins
to slip on the rollers. In normal use,
however, keep the belt as loose as
possible! The belt tension is adjusted
by turning the same screws as used for
aligning the running belt. If turning the
screws will not effect the belt tension,
please contact your local Tunturi dealer.
• Increase the treadmill's speed to 5
km/h (3 mph).
• Turn both adjustment screws an
equal amount, ¼turn clockwise.
• Try to slow the belt down by holding
onto the handrails and braking as
you walk (as if you were walking
downhill). If the belt slips, turn
another 1/4 turn and repeat the test.
When braking heavily the belt may
slip. If the belt keeps slipping despite
repeated adjustments, please contact
your local Tunturi dealer.

MALFUNCTIONS

NOTE!
Despite continuous quality control,
defects and malfunctions caused by
individual components may occur
in the equipment. In most cases it's
unnecessary to take the whole device
in for repair, as it's usually sufficient
to replace the defective part. Always
give the model, serial number of your
equipment and in case of malfunctions
also conditions of use, nature of
malfunction and any error code.
When you encounter unusual behavior
from the treadmill, simply turn the power
switch off, wait 1 minute and turn the
power switch on to reset the treadmill.
O W N E R ' S M A N U A L
This should clear incidental errors and
ready the treadmill for normal operation
again. If after you have reset the
treadmill by turning the power switch off
and on again, and the treadmill is still not
operational, contact your local Tunturi
dealer for service.
If you require spare parts, always
give the model, serial number of your
equipment and the spare part number
for the part you need. The spare part list
is at the back of this manual. Use only
spare parts mentioned in the spare
part list.

ERROR CODES

The user interface will display
information about operational faults.
E1: Speed sensor error.
Unplug the electrical cord from the wall
outlet and from the treadmill, wait 1
minute and turn the power switch on
again. If treadmill recovers to normal
operation, you may continue to use the
treadmill. Otherwise, call the dealer for
service.
E6, E7: Lift motor error.
Unplug the electrical cord from the wall
outlet and from the treadmill, wait 1
minute and turn the power switch on
again. If treadmill recovers to normal
operation, you may continue to use
the treadmill.

PROTECTIVE CIRCUIT

The machine will shut off when the
electricity load is above the machine's
capacity. To restart the machine, please
follow the procedure below:
• Unplug the power cord from the
machine's socket.
• Push in the safety switch.
• Replug the power cord into the
machine's socket.
GB
•
G O R U N 1 0
11