Selecting Remote Controller Functions From An Me Remote Controller - Mitsubishi Electric PUHY-P200 Service Handbook

[6-4 Selecting Remote Controller Functions from an ME Remote Controller ]

6-4 Selecting Remote Controller Functions from an ME Remote
Controller
In the remote controller function selection mode, the settings for four types of functions can be made or changed as necessary.
1) Skip-Auto-Mode setting
The automatic operation mode that is supported by some simultaneous cooling/heating type units can be made unselectable via the ME remote
controller.
2) Operation mode display selection mode (Display or non-display of COOL/HEAT during automatic operation mode)
When the automatic operation mode is selected, the indoor unit will automatically perform a cooling or heating operation based on the room
temperature. In this case,
This setting can be changed so that only
3) Room temperature display selection mode (Display or non-display of room temperature)
Although the suction temperature is normally displayed on the remote controller, the setting can be changed so that it will not appear on the
remote controller.
4) Narrowed preset temperature range mode
The default temperature ranges are 19 C to 30 C in the cooling/dry mode and 17 C to 28 C in the heating mode and 19 C to 28 C in the auto mode.
By changing these ranges (raising the lower limit for the cooling/dry mode and lowering the upper limit for the heating mode), energy can be saved.
NOTE
When making the temperature range setting on the simultaneous cooling/heating type units that supports the automatic operation mode to save on
energy consumption, enable the Skip-Auto-Mode setting to make the automatic operation mode unselectable. If the automatic operation mode is
selected, the energy-saving function may not work properly.
When connected to the air conditioning units that do not support the automatic operation mode, the setting for the Skip-Auto-Mode, restricted preset
temperature range mode (AUTO), and operation mode display selection mode are invalid. If an attempt is made to change the preset temperature range,
"LIMIT TEMP." appears on the display.
TEMP.
ON/OFF
CLOCK→ON→OFF
PAR-F27MEA TIMER SET
HWE14040
or will appear on the remote controller display.
will appear on the display.
Normal display [Function selection mode sequence on the remote controller]
1 1
Remote controller function selection mode
Skip-Auto-Mode setting
2
*2
Temperature range setting mode (AUTO)
2
Operation mode display selection mode (Display or non-display of the automatic mode)
5
FILTER
2
CHECK TEST
Restricted preset temperature range mode (Cooling)
4
2
Restricted preset temperature range mode (Heating)
2
Room temperature display selection mode
3
3 2
3 *1 *1
3 *2
3
2
3
- 119 -
[Normal display]
1
: Press and hold the [CHECK] and
[ ] buttons simultaneously
for two seconds.
2 : [SET TEMP. ( ) ] button
3 : [SET TEMP. ( ) ] button
3
*1 : Skip-Auto-Mode is enabled
*2 : Skip-Auto-Mode is disabled
GB