Table of Contents
Advertisement
SECTION 8 –
ENTERTAINMENT
Turn elevating crank (counter-clockwise) in
"DOWN" direction until resistance is noted
(about 13 turns). Antenna is now locked in travel
position. Turn amplifier power switch "OFF".
CAUTION
To avoid equipment damage, always
align directional handle to DOWN position
before lowering. Never partially raise or
lower antenna. Antenna must be raised
fully up into operating position or lowered
fully down into travel position.
TV SIGNAL AMPLIFIER
The TV signal amplifier is built into the
antenna and can be turned on or off with a power
switch inside the coach.
The amplifier power switch is located on a
wall plate which may be mounted in various
locations depending on floorplan. Some of these
wall plates are not easily visible and may be in
one of the following locations.
•
Inside front overhead TV cabinet (if
equipped).
•
Inside or underside of a side overhead cabinet.
•
In the optional entertainment center on the
outside of the coach.
TV Signal Amplifier Power Switch
(Some models may also have a 12-volt outlet
and/or coaxial jack on the wall plate.)
8-4
An indicator light will glow when the switch
is on and the signal amplifier is active.
Checking Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the
transmitter. Signals may vary from strong to no
usable signal at all. We recommend that the TV
system be checked out in an area known to have
good TV reception.
To check the antenna amplifier, raise the
antenna, select a TV channel and rotate the
antenna for best picture. Then turn off the
amplifier power switch. If the antenna amplifier
is working properly, the TV picture will now be
degraded (snowy). When you turn the switch
back on, the picture should again be sharp.
TV CABLE HOOK-UP
The cable television input connector is located
in the shoreline compartment on the sidewall.
Cable TV Input Hook-Up in Utility Compartment or
Shoreline Compartment depending on model
TV DIGITAL SATELLITE
SYSTEM WIRING
This coach is pre-wired for installation of a
digital satellite TV system. Coaxial cable
connections to hook up your satellite receiver are
located in the entertainment center cabinet.
A second connection may be included in an
overhead cabinet in the bedroom for the rear TV
(if equipped).
Advertisement
Table of Contents
