Table of Contents
Advertisement
SECTION 7 –
PLUMBING
Cold Water Filter Assembly below Galley Sink
(Hot waterline is not filtered)
Replacing the Cold Water Filter
Cartridge
You should replace the filter cartrige every
season and when water flow from the faucet is
too slow for convenience.
•
Place a container beneath the filter to catch
any water remaining in the waterlines during
filter removal.
•
Twist the filter cartridge counter-clockwise
about one-quarter turn, then pull it down and
out of the filter socket.
•
Insert a new water filter cartridge up into the
filter socket as far as possible and twist it
clockwise one-quarter turn until it stops.
Insert new filter up into filter socket –
Press and twist 1/4-turn clockwise
7-4
•
Purge a new filter cartridge before using for
drinking. Run a few gallons of water through
the filter and discard the water (or use for
watering plants) to avoid ingesting carbon
dust or particles that may have been present in
the new filter cartridge.
Diverter Plug
•
The temporary diverter plug is provided to
prevent water flow from the filter base in
situations when the waterline must be used
with the filter removed, such as winterization
or lack of spare filter cartridge.
•
Diverter plug is installed in the same manner
as the filter.
Diverter Plug installed in filter socket.
Insert and twist 1/4-turn clockwise,
same as filter installation
•
See Winterization Procedure at the end of this
section.
•
When removing the coach from storage,
always disinfect and flush the water system
thoroughly before installing a new filter.
After the system has been thoroughly flushed,
remove the diverter plug and store for future
use.
DISINFECTING YOUR FRESH
WATER SYSTEM
To assure complete disinfection of the potable
water system, it is recommended that the
following procedure be followed on a new
system, one that has not been used for a period of
time, or one that could have become
contaminated.
Advertisement
Table of Contents
