TuffStuff Multi-Press SP-403 Assembly Manual page 3

1
38
FIG. 1 On a flat surface, attach the
the assembled Weight Stack Frame
above, and secure it into place using two Hex Head Cap Screws 1/2-
13 X 3 1/2 (#24), four Flat Washers SAE 1/2" (#29), and two Nylon In-
sert Lock Nuts 1/2-13 (#22).
Note: Use the overhead view on the cover page for designing
your layout before assembling.
8
8
15
FIG. 3 Carefully begin sliding the Weight Plates (#8) onto the
Guide Rods (#4), in position as shown above, allowing the first one
to rest on top of the Rubber Donuts (#15).
SP-403 Multi-Press
Bottom Cross Brace (#38)
(#1), in the position as shown
4
15
9
5
to FIG. 2 Remove the
Selector Bar (#9)
8
FIG. 4 Slide the
Rods (#4) allowing it to rest on top of the completed Weight Stack.
Note: Be sure the label on the
facing out, as shown above, before sliding the
lector Bar (#9)
Owner's Manual: Assembly Instructions
87
1
4
38
Guide Rod Retainer (#5), and the
to allow the assembly of the weight plates.
Label
9
4
Top Plate Selector Bar (#9)
Top Plate Selector Bar (#9)
onto the Guide Rods (#4).
Top Plate
onto the Guide
is
Top Plate Se-
2