Coupling Shaft Breakage Of Transfer Belt Unit Rear Side - Konica Minolta bizhub PRO C6501 Troubleshooting Manual

32 Coupling shaft breakage of transfer belt unit rear side

[Symptom]
When removing transfer belt unit at the maintenance and the belt is rotated, the phase of the
couplings at the rear side of transfer belt unit and main body becomes different.
Consequently, the process carriage cannot be inserted smoothly. At such occasion, if the
process carriage is inserted forcibly, the coupling shaft of the transfer belt unit may breaks at
the e-clip groove.
[Cause]
The phase of the couplings on the transfer belt unit and main body side does not match.
[Solution]
1) After removing then installing the transfer belt unit, insert the process carriage slowly and
carefully.
2) If interfere is recognized at the insertion, stop the insertion once then pull out the process
carriage, turn the coupling of transfer belt unit slightly then retry.
Transfer belt unit side
Table of contents
Main body side
44