Precor C842i Service Manual page 34

Diagram 7.4 - Hand Held Heart Rate Cable
Seat
Cable
6. Slide the seat rail cable back into the access hole. The seat carriage must travel over this
cable, so it must be below the surface of the seat rail. Release the seat lever, hold the cable
attached to the seat straight back from the seat as you slide the entire seat and seat
carriage off of the rear of the seat rail. See Diagram 7.5.
Diagram 7.5 - Hand Held Heart Rate Cable
7. Remove the plate that covers the hand held heart rate cable on the bottom of the seat. See
Diagram 7.6. The cable may be stuck to the plate with double sided tape.
C842i, C846i Upright and Recumbent Cycle
Seat Rail
Cable
Page 34