Precor C842i Service Manual page 10

11. U-BOOT SW display. This display the installed version of upper boot software. The boot
software is used to upload new software into the upper display PCA.
12. Press the OK key. The software part number will be displayed as XXXXX-XXX.
13. Press the BACK key to exit the U-Boot SW display.
14. U-BASE SW display. This display the installed version of upper PCA software.
15. Press the OK key. The software part number will be displayed as XXXXX-XXX.
16. Press the BACK key to exit the U-Base SW display.
17. LOWER SW display. This display the installed version of lower PCA software.
18. Press the OK key. The software part number will be displayed as XXXXX-XXX.
19. Press the BACK key to exit the lower SW display.
20. SER. NUMBER display. Press the OK key.
21. The treadmill's serial number will be displayed. The serial number may be incorrect or not
displayed if the upper PCA has been replaced.
22. Press the BACK key to exit the serial number display.
23. USAGE LOG display. Press the OK key.
24. Use the , keys to move through the list of programs. A message will scroll describing the
program, the number of times and the number of minutes the program was used.
25. Press the BACK key to exit the usage log display.
26. ERROR LOG display. Press the OK key, the quantity of errors in the log will be displayed.
27. Press the OK key, the most recent error will be displayed first.
28. Use the , keys to move through the list of errors. The error messages will list the error
name, the odometer reading when the error occurred, the hour meter when the error
occurred and the drive motor current reading when the error occurred.
29. Press the RESET key to exit the information display.
C842i, C846i Upright and Recumbent Cycle
Page 10