Sony BVM-L230 Operation Manual page 8

The signal delay is decreased by judging the animation or
still picture from the past video signal.
Interlace display mode
The interlace signal is displayed as the interlace picture by
inserting the black line without I/P conversion processing.
A picture faithful to the original signal and with the same
feel as a CRT is gained.
For setting the display, see "Selecting Display Mode" on
page 62.
Black frame insertion display mode
Motion blur caused by the holding-type display of the LCD
is decreased by inserting the black frame between the
picture frames in double frame rate (100/120Hz) operation
of the LCD panel.
For setting the display, see "Selecting Display Mode" on
page 62.
Available to a multi signal format
The monitor supports various input signals such as 720 ×
576/50i to 1920 × 1080/50P, 60P, digital cinema (D-Cine)
2048 × 1080/24P and variable computer signals up to
WUXGA (1920 × 1200). A DVI-D (HDCP
correspondence) and four option slots are equipped as the
interface and the monitor supports HD-SDI, SDI, RGB,
YPbPr, Y/C, composite and Dual-link HD-SDI signal
input.
Safe area marker and aspect marker functions
The monitor is equipped with two area markers and center
marker as the safe area marker and aspect marker for
confirming the picture angle.
For the operation, "Displaying the Area Marker or Aspect
Marker" on page 64.
Scan selection/Native scan display function
You can select from under scan (–3%), normal scan (0%)
and over scan (mask of the 5% over scan portion in the
normal scan) for the picture display.
The monitor is equipped with a native scan display
function which maps the pixel of the signal to the panel in
one to one mode.
For the operation, "Selecting the Native Scan/Scan Mode"
on page 63.
Aspect selectable function
A squeezed and recorded signal is displayed with the
correct angle. You can select from 4:3, 16:9, 1.896:1 and
2.39:1* aspect modes.
* When the aspect ratio is set to 2.39:1, the resolution is
reduced.
8
Features
Remote control function (Ethernet control)
The controller controls up to 32 monitors by the Ethernet
(10BASE-T/100BASE-TX) connection. Up to four
controllers are connected to one monitor in single mode.
You can control individual monitors or monitor groups
simply by entering the monitor ID number or group ID
number. You can also execute the same operation on all
connected monitors, or put all connected monitors into the
same setup and adjustment state.
Variable picture adjustment functions
Auto chroma, phase and matrix adjustment function are
equipped. The white balance is automatically adjusted by
using a commercially available probe (Konica Minolta
CA-210, DK-Technologies PM5639/06, X-Rite Eye-One
Pro).
Other features
• The color temperature is selectable from D65, D93, D61,
D56, D-Cine and User.
• Chroma Up function that increases the chroma setting by
12 dB.
• Blue only function and RGB cut off function to monitor
signal noise.
• A parallel remote of the contact point control connector
is equipped.