Sony BVM-L230 Operation Manual page 49

Menu
User Data
Matrix
Gamma
Native Scan Mode
Aperture Value
NTSC Comb Filter
Filter Switch
Function and operation ([
Selects the user data of Decoder Color Profile.
You can select from User1 to User5. [User1]
Sets the transmission matrix.
[ITU709]: Matrix of ITU-R BT.709 standards
ITU601: Matrix of ITU-R BT.601 standards
SMPTE 240M: Matrix of SMPTE-240M standards
Note
The internal fixed value applies to the transmission matrix of the RGB format and XYZ format.
Sets the transmission gamma.
[2.2]: Transmission gamma 2.2
2.6: Transmission gamma 2.6
RGB Full Range: Transmission gamma available when the Full Range signal in
quantization is input
S-LOG Standard: Log gamma available with the F23 Digital Cinematography Camera.
Select to run the 100% output level of the F23 with the 100% level of the monitor for
confirmation.
S-LOG Full: Log gamma available with the F23.
Select to fit the full dynamic range of the F23 in the 100% level of the monitor for
confirmation.
Note
As 2.6 (transmission gamma 2.6) is the setting for the XYZ format, the signal is not displayed
correctly except for the XYZ format input.
Sets the native scan mode.
[×1]: The input signal display without conversion
×2: The input signal display in two times
For selecting ×1 or ×2, see "Picture Display Size" on page 75.
Sets the aperture modification value.
Sets to 000 to 200. [000]
For aperture modification frequency, see page 74.
Sets the type of NTSC filter.
You can select from [3Lines] or 3D.
When the BKM-227W is installed, you can select the item.
Sets whether or not to turn on the Y/C separation filter ([Off] or On) when the picture is set to
monochrome mode.
When the BKM-227W is installed, you can select the item.
]: factory setting)
49
Display Setting Menu