Sony BVM-L230 Operation Manual page 55

Menu
1 Pin to 8 Pin
Power
Standby Mode
Function and operation ([
Assigns the function to each pin of the PARALLEL REMOTE connector when Parallel Remote
is set to On.
1 Pin: [CH01]
2 Pin: [CH02]
3 Pin: [External Sync]
4 Pin: [Mono]
5 Pin: [Marker]
6 Pin: [unused]
7 Pin: [unused]
8 Pin: [Tally]
You can change the assignment to the following functions for pins 1 to 8.
Parallel Remote (1/3)
CH01 to 30: Selects a channel number. Enter the desired channel number with the
numeric buttons.
----: Unused
Under Scan: The under scan function. When it is set to off, the scan mode is set to
Normal Scan.
Over Scan: The over scan function. When it is set to off, the scan mode is set to Normal
Scan.
Native Scan: The native scan function
16:9: The 16:9 or 1.896:1 (digital cinema signal 2048 × 1080) aspect ratio function.
When it is set to off, the aspect ratio is set to 4:3 or 2.39:1.
The aspect ratio may be fixed to 16:9 due to the signal format. For details, see "Available
Signal Formats" on page 70.
H Delay: The horizontal sync display function
V Delay: The vertical sync display function
External Sync: The synchronization function to external sync signals
Comb: The comb filter function. When it is set to off, the trap · band-pass filter (Trap/
BPF) is selected.
You can select the type of comb filter in NTSC Comb Filter menu (page 49) of the Display
Setting menu.
Parallel Remote (2/3)
Aperture: The aperture modification function
Mono: The monochrome display function
Blue Only: The function by which red and green signals are cut and only the blue signal
is displayed as a monochrome picture
R Off: The cutting function of red signals
G Off: The cutting function of green signals
B Off: The cutting function of blue signals
Chroma Up: 12 dB up function of the chroma setting value
Tally: The function to turn on the tally lamp
Parallel Remote (3/3)
Marker: The display function of all markers set in the Marker menu
Aspect Marker: Not available in software version 1.1 or earlier.
Area Marker 1: Not available in software version 1.1 or earlier.
Area Marker 2: Not available in software version 1.1 or earlier.
Side by Side: Not available in software version 1.1 or earlier.
Wipe: Not available in software version 1.1 or earlier.
Butterfly: Not available in software version 1.1 or earlier.
Blending: Not available in software version 1.1 or earlier.
Error Notify Clear: Not available in software version 1.1 or earlier.
Power Off: The monitor power function
For the pin assignment, see "PARALLEL REMOTE connector" in Location and Function of
Parts on page 14.
Sets the status of the monitor when the main power is turned on or the power is turned on by
remote operation.
Sets the status when the MAIN POWER switch is turned on.
[Off]: Operation mode
On: Standby mode
]: factory setting)
55
System Configuration Menu