Advertisement
7. Set transition media tray into position as shown in Figure
16. The return bends are at the bottom of the tray. The
rear return bend should be positioned in between the
glass frame and the glass frame bracket. Ensure tray
is positioned fl ush with appliance opening.
Figure 14. Form Transition Glass Panel Bracket
FORM
FORM
HAND BEND
HAND BEND
Heat & Glo • Primo Clean Face Finish Instructions • 2310-925 Rev. D • 8/15
8. Install glass transition panel bracket on left and right
sides of appliance opening using two self-tapping
screws. See Figures 14, 15 and 16 for details.
9. Install transition glass panels by securing with tabs on
left and right sides of appliance. See Figures 16 and
17.
INSIDE VIEW OF OUTER WRAP
TRANSITION GLASS PANEL BRACKET
SELF-TAPPING SCREWS GO
SELF-TAPPING SCREWS GO
THROUGH EXISTING HOLES
THROUGH EXISTING HOLES
EXISTING HOLES
EXISTING HOLES
Figure 15. Install Transition Glass Panel Bracket
7
Advertisement
