Advertisement
WARNING! Risk of Fire, Explosion or Asphyxiation!
DO NOT use screws more than 3/4 inch long on lower
access cover panel. Longer screws may penetrate gas
line or damage valve or electrical components.
The appliance is designed to be used with 1/2 in. wall
sheathing materials such as drywall, plywood, wood
composites, or non-combustible materials.
Note: It is acceptable to use a high temperature silicone
sealant to adhere drywall to lower access cover panel.
Finish and Sealing Joints
All joints between the fi nished wall sheathing and the ap-
pliance must be sealed with non-combustible materials.
Sealants, such as caulk or mastic used to seal the gap
between the wall and the fi replace, should be rated at a
minimum continuous exposure to 300ºF.
Facing Material
• Facing and/or fi nishing materials must never overhang
into the glass opening. See Figure 2.
• Facing materials may be combustible or non-combustible.
WARNING! Risk of Injury! Risk of Explosion! Install fasteners as instructed.
• Gas train could be damaged causing a gas leak.
• Electrical components could be damaged causing electrical shock.
• LED'S could be damaged.
• Glass installation could be obstructed.
Note: It is acceptable to use a high temperature silicone
sealant to adhere drywall to lower access cover panel.
Figure 1. Screw Length Requirements
2
= NO FASTENERS IN THIS AREA
= 3/4 INCH MAX. LENGTH FASTENERS IN THIS AREA
Heat & Glo • Primo Clean Face Finish Instructions • 2310-925 Rev. D • 8/15
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specifi ed in
this manual. Overlapping materials could ignite and will
interfere with proper operation.
Painting
If desired fi nishing includes a painted wall, 100% acrylic
latex, oil-based or standard acrylic paints may be used.
Follow paint manufacturer's instructions for paint and
primer application.
2 IN.
1/2 IN.
Advertisement
