Heat & Glo PRIMO48-CF Installation Instructions Manual page 5

B
*Back panel used in single-sided models only.
Figure 6. Placement of Panels
Figure 7. Retaining Bracket Installation
NOTICE: Fasteners are not used with glass clip.
Figure 8. Position Glass Clip and Install Glass Panel
A* C
RETAINING BRACKET
DETAIL
Heat & Glo • Primo Clean Face Finish Instructions • 2310-925 Rev. D • 8/15
5. Break the barrier glass support into two pieces as shown
in Figures 9 and 10. Make the hand bends as shown
in Figure 11 to form the glass supports
BREAK LINE BREAK LINE
Figure 9. Barrier Glass Support
Figure 10. Break Barrier Glass Support
HAND BEND AT 90 DEGREES HAND BEND AT 90 DEGREES
Figure 11. Form Barrier Glass Support
5