Panasonic KX-VC300 Operating Instructions Manual page 60

Controlling a PTZ Camera
3 Press the buttons of the remote control to operate the
PTZ camera.
[B]: Zoom out
[R]: Zoom in
[ ][ ]: Pan the camera left/right.
[ ][ ]: Tilt the camera up/down.
•
The movement continues as long as you hold down
the button, and stops when you release the button.
For finer control of the movement, press the button
and immediately release it, and repeat this in
succession.
•
To control another site's PTZ camera, press [Y].
Each time [Y] is pressed, the order of the sites listed
in the site selection dialog box will change.
Example: During a 4-party video conference call
Site 1 Site 2
•
To return to the video conference call screen, press
[Back].
Note
•
You can press [Full Screen] on the remote control to display/hide the guide area.
•
In order for other parties to be able to control your PTZ camera, you must set "CAM ctrl from remote
site(s)" in your settings to "ON" (by default, it is set to "OFF") (Page 92).
•
If any of the other parties is using an older software version, you will not be able to control any of the
other party's PTZ cameras. You will only be able to control your own PTZ camera.
•
If the other party is using a KX-VC500, you will not be able to control their PTZ cameras. The other
parties will be able to control your PTZ camera.
•
In the following cases, you will not be able to control a PTZ camera, even if you press [CAM Ctrl].
–
While contents are being shared.
–
While displaying the unit information screen or the connections status screen.
–
While displaying a dialog box.
60 Operating Manual
Site 3 Local Site
Site 1
Site 2
Site 3
Document Version 2012-03