Compare Sonar Beams (Split Sonar View) - Humminbird HELIX 9 Operation Manual

C S
OMPARE ONAR
Split Sonar View displays sonar returns from each down beam frequency on separate sides of the view. You can use this view to make
side by side comparisons between the sonar returns from both beams. The beams are determined by your Humminbird model and
the installed transducer.
Frequencies: HELIX SONAR GPS models and HELIX SI GPS models allow you to compare the 83 KHz and 200 kHz beams in this
view. If you have a HELIX DI GPS model, 455 kHz and 200 kHz will be displayed side by side in this view.
Fish ID+: It is also helpful to turn on Fish ID+ in Split Sonar View so you can see where the fish are located within each transducer
beam (see Adjust Sonar Display Settings: Turn on/off Fish ID+ Settings).
Display the Split Sonar View
1. Press and hold the VIEW key.
2. Select Sonar > Split Sonar View.
frequency
Sonar (2D)
B
EAMS
Reviewing Beams Separately in Split Sonar View (83 kHz/200 kHz)
83 kHZ
lower range frequency
48
(S
200 kHZ
lower range
S V )
PLIT ONAR IEW
upper range