Output Shaft Bearing Play - Foley Engines ZF 45 C Repair Manual

Repair Manual and Spare Parts List ZF 45C / 63C / 88C
Take measurement "M" between cover (35) mating surface
and the surface shown on figure V5.
Select proper thickness shims (75) (76) to set the gap "I".
"I" = 0.008" to 0.02"
(0.2 mm to 0.5 mm)
"I" = "M" - "L"
Fig. V5
WARNING
To check the play, once the gearbox is assembled, use
tool clamp ring P.N. 618582, as shown in figure V6.
Set down to the housing the input shaft and measure
with a dial indicator the play "I" moving the input shaft
with the aid of two prybars.
Fig. V6
CAUTION

4. OUTPUT SHAFT BEARING PLAY

This measurement has to be taken only is housing (36) is
replaced.
Install snap ring (70) in housing (36).
Take measurement "S" as shown in picture V7.
Remove snap ring (70) and measure its thickness "V".
Measure width "R" of the bearing.
Select proper thickness shims (68) (69) to set maximum
play "Z"
"Z" = "S" - "V" - "Q"
"Z" = 0,004" (0.1 mm)
Fig. V7
25