Optical Drive Connector - HP Envy Notebook 17 Maintenance And Service Manual

Optical drive connector

Description
Optical drive connector
Before removing the optical drive connector, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
To remove the optical drive connector:
1. Position the computer upright.
2. Disconnect the optical drive connector cable from the system board (1).
3. Remove the two Phillips PM2.5×3.0 screws (2) that secure the optical drive connector to the computer.
4. Remove the optical drive connector and cable (3).
Reverse this procedure to install the optical drive connector.
42 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 23).
Optical drive on page
Bottom cover on page
24).
28).
Spare part number
810928-001