Optical Drive Connector Board - HP 15-bs0 Series Maintenance And Service Manual

Optical drive connector board

Description
Optical drive connector board
Optical drive cable
Before removing the optical drive connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
To remove the optical drive connector board:
1. Disconnect the cable from the optical drive connector board (1).
2. Remove the Phillips PM2.0×2.0 screw (2) that secures the optical drive connector board to the computer.
3. Rotate the connector side of the board upward, and then pull the board up and out of the computer (3).
Reverse this procedure to install the optical drive board connector.
52 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 34).
Optical drive on page
Bottom cover on page
35), if installed.
45).
Spare part number
924990-001
924926-001