5.
Remove the optical drive (see
6.
Remove the bottom cover (see
7.
Remove the fan (see
To remove the heat sink assembly:
1.
Position the computer upright and open it.
2.
If you have a model with discrete graphics, in the order indicated, remove the six Phillips PM2.0×3.0
screws (1) that secure the heat sink to the system board.
3.
Remove the heat sink (2) from the system board.
4.
If you have a model with UMA graphics, in the order indicated on the screws, remove the six Phillips
PM2.0×3.0 screws (1) that secure the heat sink to the system board.
Optical drive on page
Bottom cover on page
Fan on page
37).
24).
28).
Component replacement procedures
39