Touchpad - HP Envy Notebook 17 Maintenance And Service Manual

TouchPad

Description
TouchPad board with cable
Before removing the TouchPad, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the system board (see
To remove the TouchPad:
1. Remove the three Phillips PM2.5×3.0 screws (1) that secure the TouchPad bracket to the computer.
2. Remove the bracket (2).
3. Lift the keyboard cable (1) to gain access to the TouchPad screws.
4. Remove the three broadhead Phillips PM2.0×2.0 screws (2) that secure the rear bracket and the
TouchPad to the computer.
50 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 23).
Optical drive on page
Bottom cover on page
System board on page
24).
28).
43).
Spare part number
811552–001