Operation; First Time Use Of The Oven; Oven On And Off; Setting The Clock - Logik LBMULX10 Instruction & Installation Manual

First Time Use of the Oven

Unpack the oven. Remove any insert cards or plastic bags. Use a damp cloth to carefully wipe the interior
and exterior of the oven. Clean all the detachable parts in hot, soapy water before using.
Heat the oven on maximum for 30mins. There may be a little smoke and odour upon initial start up (for
about 15mins). This is normal. It is due to the protective substance on the heating elements which protects
them from the effects of corrosion during shipping from the factory.

Oven On and Off

In order to switch on the oven you need to:
1. Set required working conditions of the oven, its temperature and a mode of heating.
Set the Function Control to the required position, turning it right.
2.
3. Press the Manual button to start the oven. The blue lamp above the button will illuminate, and after
5 seconds the RED RUN lamp will light to show the oven is operating.
During use the appliance become hot. Care should be taken to avoid touching
heating elements inside the oven.

Setting the Clock

1. Press the button two times then press the
and then press the
2. Wait for 5 seconds or press the

Natural Convection Oven

The oven can be warmed up using the bottom and top heaters, as well as the
grill. Operation of the oven is controlled by the oven Function Control — to
set a required function you should press in to release the Function Control
and then turn to the selected position.
As well as the temperature regulator Temperature Control — to set a
required temperature you should press in to release the Temperature Control
and then turn to the selected position.
The oven can be switched off by setting both of these controls to the off
position " " / "0".
GB-6
or
or button to set the minutes.
button again.
button to set the hour, press the
Function Control
Temperature Control
button again
˚C