Radio Operation - Jensen SAB-55A User Manual

3. Within seven seconds, press the TUNER UP (#7) / TUNER DOWN BUTTON (#6)
repeatedly until the correct hour is reached.
4. Press the MEM/TIME BUTTON (#9) again and the minute digits on the display will
blink.
5. Within seven seconds, press the TUNER UP BUTTON (#7) / TUNER DOWN
BUTTON (#6) repeatedly until the correct minute is reached.
6. Press the MEM/TIME (#9) to confirm the time.
Note:
Make sure the hour is set so that AM or PM is correctly displayed. If the PM
INDICATOR (#22) is showing on the display, the displayed time is "PM". If the AM
INDICATOR (#22) is showing on the display, the time displayed is "AM".
1. Insert the earbuds into the EARPHONE JACK (#12) and press and hold the
POWER / BAND BUTTON (#1) to turn on the radio.
2. Press the POWER / BAND BUTTON (#1) repeatedly to select AM or FM.
3. Press and hold the TUNER UP BUTTON (#7) / TUNER DOWN BUTTON (#6) to
search next / previous available station. If the reception is poor, try Manual Tuning
to fine-tune the station. Press the TUNER UP BUTTON (#7) / TUNER DOWN
BUTTON (#6) briefly to manually tune through the frequency band.
4. Adjust the VOLUME UP/DOWN BUTTONS (#5/#4) to obtain the desired sound
level.
5. Press the BASS BUTTON (#3) to enhance the bass effect of the music being
played. Press the BASS BUTTON (#3) again to turn the effect off.
6. Press and hold the POWER / BAND BUTTON (#1) to turn off the SAB-55A when
finish listening. The SAB-55A will display the time.
TIPS FOR BEST RECEPTION
FM - The FM radio uses the cord from the earbuds as the antenna. Unwrap and
extend the cord for best reception. The FM STEREO INDICATOR will show on the
display when receiving a stereo broadcast and signal is strong enough.
AM - The AM antenna is located inside the cabinet of the unit. If AM reception is weak,
change the position of the SAB-55A until the internal antenna picks up the
strongest signal.

RADIO OPERATION

E-6