Inserting A Bobbin/Threading Lower Thread; Removing The Bobbin From The Bobbin Case; Removing/Inserting Bobbin Case - Bernina 710 Manual

Inserting a bobbin/threading lower thread

1
2

removing/inserting bobbin case

1
3

removing the bobbin from the bobbin case

⦁ press the release lever at the bobbin case (see illustration «Changing
bobbin case» on this page)
⦁ remove the bobbin case according to following description
⦁
insert the bobbin so that the thread is wound counterclockwise 1
⦁
pull the thread from the left into the slot
⦁ pull the thread to the right under the spring 2
⦁
lead the thread beneath the thread guide and pull upwards
►
the thread is threaded in the guide
⦁ pull the thread
►
the bobbin must turn counterclockwise
removing the bobbin case
⦁
raise the needle
⦁
turn power switch to «0» (off)
2
⦁ open bobbin cover 1
⦁ press bobbin release 2
⦁
remove the bobbin case
Inserting the bobbin case
4
⦁ hold the bobbin case with the thread guide 3 pointing upwards
4
⦁ put the thread guide into the notch 4 of the hook race cover
⦁ insert the bobbin case and press in the center until it clicks into place
Bobbin thread cutter
⦁
pull the thread over thread cutter 5 to cut it
⦁
close the cover
5
033805.51.04_2014-02_Manual_B710_EN
Sewing preparation
21