Positioning The Speakers - Sony mhc-gzr99d Operating Instructions Manual

Positioning the
speakers
To install the satellite speakers on the
wall (MHC‑GZR99D/GZR88D only)
1
Prepare screws (not supplied) that
are suitable for the hole on the back
of each speaker. See the illustrations
below.
4 mm
more than 25 mm
2
Fasten the screws to the wall.
The screws should protrude 5.5 to
7 mm.
5.5 to 7 mm
5.3 mm
9 mm
Hole on the back of
the speaker
3
Hang the speakers on the screws.
Hole on the back of
the speaker
Notes
 Use screws that are suitable for the wall
material and strength. As a plaster board wall
is especially fragile, attach the screws securely
to a beam and fasten them to the wall. Install
the satellite speakers on a vertical and flat
wall where reinforcement is applied.
 Contact a screw shop or installer regarding
the wall material or screws to be used.
 Sony is not responsible for accident or
damage caused by improper installation,
insufficient wall strength or improper screw
installation, natural calamity, etc.
5.3 mm
9 mm

GB