Additional Information; Troubleshooting - Sony mhc-gzr99d Operating Instructions Manual

Additional Information

Troubleshooting

Should you encounter a problem with
your system, do the following:
1
Make sure the power cord and
speaker cords are connected
correctly and firmly.
2
Find your problem in the
troubleshooting checklist below and
take the indicated corrective action.
If the problem persists after doing all
of the above, consult your nearest Sony
dealer.
If the STANDBY indicator flashes
Immediately unplug the power cord,
and check the following items.
 If your system has a voltage
selector, is the voltage selector set
to the correct voltage?
 Are you using only the supplied
speakers?
 Are the + and  speaker cords
short-circuited?
 Is anything blocking the ventilation
holes on the rear of the system?
After the STANDBY indicator stops
flashing, reconnect the power cord,
and turn on the system. If the issue
persists, contact your nearest Sony
dealer.
General
The display starts flashing as soon
as you plug in the power cord even
though you have not turned on the
system.
 Press DISPLAY once while the system
is off. The demonstration disappears.
"– –:– –" appears in the display.
 A power failure has occurred. Set the
clock (page 36) and timer settings
(page 98) again.
The system does not turn on.
 Is the power cord plugged in?
 Is the voltage selector set correctly to
match the local power line voltage?
(For models with a voltage selector
only)
The clock or timer setting is canceled.
 The power cord is disconnected or a
power failure occurred. Redo "Setting
the clock" (page 36). If you have set
the timer, redo "Using the timers"
(page 98).
There is no sound.
 Press VOLUME + repeatedly (or
turn MASTER VOLUME on the unit
clockwise).

Continued
109
GB