Fluorescent Lamp - Toshiba Satellite R10 Maintenance Manual

4 Replacement Procedures

4.31 Fluorescent Lamp

This system uses LCD modules from the following suppliers. The procedure for replacing
the fluorescent lamp is different for each LCD module. Refer to the appropriate procedure.
Type
14.1 inch G33C0002J110
Note: - When working with an LCD module, always use a flat, grounded table.
- Handle the backlight unit in the environment without dust, such as on the clean
bench. Keep the work table free from any screws or other material that may
scratch the LCD surface.
- Use an anti-static or protective sheet.
- When replacing the FL unit, cover with a finger protector or similar to prevent
dirtying or scratching the LCD panel.
- Take care when handling the lamp. Excessive force may break the lamp.
- Take care not to dirty or deform the lamp reflector.
- Ensure a lways that the power of the LCD module is turned off before
connecting or disconnecting cables and connectors.
Satellite R10 Maintenance Manual (960-509)
Part. No Supplier
CMO
4.31 Fluorescent Lamp
Section
4.31.1
4-69