System Board - Toshiba Satellite R10 Maintenance Manual

4.19 System board

4.19 System board

Removing the system board
The following describes the procedure for removing the system board. (See Figure 4-30.)
1. Disconnect the mic (R) cable from the connector CN6061 on the system board
2. Disconnect the rotation sensor cable from the connector CN3280 on the system
board
3. Disconnect the digitizer cable from the connector CN9540 on the system board
4. Remove the following screws securing the system board.
M2.0x6.0B
?
5. Remove the system board from the cover assembly while pulling it up toward
arrow pointing.
Mic (R) cable
(Connected to CN6061)
System board
4-44
FLAT BIND screw
Rotation sensor cable
(Connected to CN3280)
Figure 4 -30 Removing the system board
4 Replacement Procedures
x1
M2.0x6.0B FLAT BIND
Digitizer cable
(Connected to CN9540)
Satellite R10 Maintenance Manual (960-509)