Toshiba Satellite R10 Maintenance Manual page 301

4.29 LCD/digitizer harness & Wireless LAN antenna cables 4 Replacement Procedures
Installing the LCD/digitizer harness & wireless LAN antenna cables
The following describes the procedure for installing the LCD/digitizer harness & wireless
LAN antenna cables. (See Figure 4-43 and 4-45.)
1. Stick the wireless LAN antennas on the display cover and arrange their cables.
2. Stick the acetate tape (5 points) on the display cover.
Wireless LAN antenna
Acetate tape
Figure 4 -45 Arranging the wireless LAN antenna cables
3. Pass the LCD harness through the hole of hinge assembly.
4. Pass the digitizer harness through the hole of hinge assembly.
5. Pass the wireless LAN antenna cables through the hole of hinge assembly.
6. Installing the hinge cap to the hinge assembly, secure the hinge assembly to the
display cover with the following screws .
M2.5x6.0B
?
Caution: Before installing the hinge cap, confirm the right arrangement of each
harnesses and cables.
7. Arranging the LCD harness on the display cover, secure the LCD harness ground
plate with the following screws .
M2.5x6.0B
?
8. Arranging the digitizer harness on the display cover, install the digitizer harness
hold plate.
9. Install the cover assembly and hinge rear cover to the display cover.
4-66
FLAT BIND screw
FLAT BIND screw
Acetate tape
x2
x2
Satellite R10 Maintenance Manual (960-509)