Toshiba Satellite R10 Maintenance Manual page 299

4.29 LCD/digitizer harness & Wireless LAN antenna cables 4 Replacement Procedures
4.29 LCD/digitizer harness & Wireless LAN antenna cables
Removing the LCD/digitizer harness & wireless LAN antenna cables
The following describes the procedure for removing the LCD/digitizer harness & wireless
LAN antenna cables. (See Figure 4-43 and 4-44.)
1. Pull out the wireless LAN antenna cables from the guide.
2. Remove the following screws and LCD harness holder .
M2.5x2.8B
?
3. Remove the following screws and digitizer harness holder.
Unique screw CPU stud screw
?
M2.5x6.0S
?
4. Remove the following screws securing the hinge assembly.
M2.5x6.0B
?
M2.5x6.0S
?
5. Remove the hinge rear cover from the hinge assembly.
6. Detach the cover assembly from the display cover.
M2.5x2.8B FLAT BIND
M2.5x6.0B FLAT BIND
Digitizer harness holder
4-64
FLAT BIND screw
PSP TIGHT screw
FLAT BIND screw
PSP TIGHT screw
CPU stud
Figure 4-43 Removing the cover assembly
x1
x1
x1
x1
x1
LCD harness holder
M2.5x6.0S PSP TIGHT
Hinge rear cover
Satellite R10 Maintenance Manual (960-509)