Table of Contents
Advertisement
9
Preparation
9
Inserting the needle
.01
1
Fig. 9 - 01
All regulations and instructions in this Instruction Manual are to be observed!
Special attention is to be paid to the safety regulations!
All preparation work is only to be carried out by appropriately trained personnel.
Before all preparation work, the machine is to be separated from the electricity
supply by removing the plug from the mains or switching off the On/Off switch!
2
The selection of the correct needle depends on the model of the machine and the
material and threads being sewn ( see chapter 3.02 Needle and thread ).
Turn the machine off!
Use only system 134-35R needles.
Raise roller presser 1.
Swing the eye guard upwards.
Pull roller presser 1 downwards slightly
and swing it out to the left.
Loosen screw 2 and insert needle 3 until
you feel it stop. The long groove must be
facing the left.
Tighten screw 2 and swing the roller
presser back.
Preparation
9 - 1
Advertisement
Table of Contents
