Table of Contents
Advertisement
Controls
Starttack on/off
Endtack on/off
Backtack suppression
Program key
Parameter input
Keys F1 – F5
to
Needle position
Presser foot position when sewing stops
Presser foot position after thread trimming
Thread trimmer on/off
Enter key
7 - 4
With this key the starttacks can be switched on or off.
When the LED is on, starttacks are sewn.
With this key the endtacks can be switched on or off.
When the LED is on, endtacks are sewn.
Press the key once: starttacks are not sewn.
Press the key twice: start- and endtacks are not sewn
When this key is activated (LED is on), a "program" (stitch length values) can be entered
and selected with the knee switch.
After this function has been activated (LED is on) you are in the parameter input function.
After the function has been switched off, you return to sewing mode.
These keys have no function in sewing mode.
When the code number is entered, these keys correspond to the numbers 1 – 5.
The needle position can be selected with this key.
When the function is switched on (LED on): The needle positions at t.d.c. when sewing stops.
When the function is switched off (LED off): The needle positions at b.d.c. when sewing stops.
When the code number is entered, this key corresponds to number 6.
The position of the presser foot when sewing stops can be selected with this key.
When the function is switched on (LED on): The presser foot is raised when sewing stops.
When the function is switched off (LED off): The presser foot is lowered when sewing stops.
When the code number is entered, this key corresponds to number 7.
The position of the presser foot after thread trimming can be selected with this key.
When the function is switched on (LED on): The presser foot is raised after thread trimming.
When the function is switched off (LED off): The presser foot is lowered after thread trimming.
When the code number is entered, this key corresponds to number 8.
With this key the thread trimmer can be switched on or off.
When the LED is on, the thread can be trimmed with the pedal function.
When the code number is entered, this key corresponds to number 9.
This key has no function in sewing mode.
When the code number is entered, the number sequence is taken over by pressing this key
( enter function ).
Advertisement
Table of Contents
