Table of Contents
Advertisement
Adjustment
12.
Tension unit control
06
12 - 36
Requirement
When the roller presser touches the material
1. For materials up to 2 mm one tension unit should be active ( magnet activated )
2. For materials over 2 mm the second tension unit should be connected ( magnet
drops out )
2
Fig. 12 - 33
Activate magnet 1.
Adjust magnet 1 ( screws 2 ) according to requirement 1.
Adjust switch lug 4 ( screw 5) according to requirement 2.
This is a basic setting and can be changed depending on the material thickness.
1
3
0.5 mm
Advertisement
Table of Contents
