Water Drainage - Miele PW 5064 Operating Instructions Manual

Hot water connection
Connecting the machine to a hot water
supply will lead to low electrical
consumption during hot water
operation. The hot water temperature at
the water supply valve must not exceed
158°F (70°C).
The water in single water lines from the
hot water source cools down when not
in constant use. In that case, more
electricity will be used to heat the wash
water.
The same conditions apply for the hot
water connection as for the cold water
connection.
Connect the hot water inlet hose (red
mark) to the water supply.
Connecting the machine to a hot
water line only is not possible for
functional reasons.
If the washer is not to be installed with a
hot water connection, the settings
Main wash Water , Pre-wash Water and
Rinse Water must be adjusted
accordingly. The hot water inlet hose
must be removed.
^ In the menu Settings / Supervisor
level, select the option cold.
The program times may be
extended.
^ Unscrew the hot water inlet hose (red
mark).
^ Screw on the supplied stopper.

Water drainage

The machine is drained with a
motorized drain valve. A connection
can be made to an on-site floor drain
(gully with an air gap) on an angle.
Installation
51