Hob - Belling 152 Installation And User Instruction Manual

To use the hob
Safety
requirements
for deep fat
frying
How to deal with
a fat fire
Relighting the
burner
20

Hob

The hob lid is fitted with a safety device which cuts off the gas
supply to the hotplate burners unless the lid is fully open. Do not
use the safety device as a means of controlling the hotplate
burners.
The hob has one ultra rapide wok burner, two rapide burners, two
semi-rapide burners and two auxiliary burners which will
accommodate pans between 100mm (4") and 230mm (9")
diameter. All pans should be positioned centrally over the burners.
1. Check that the electricity supply is switched on.
2. Push in and turn the control knob of the chosen burner
anti-clockwise to the large flame symbol
ignition button until the spark lights the gas.
3. Turn the control knob anti-clockwise to the desired
setting. Only turn the control knob between the large
flame symbol
adjusting the setting.
4. To turn off, turn the control knob fully clockwise.
DO NOT use mis-shapen pans which may be unstable.
DO NOT use round base woks directly on the pan supports.
DO NOT use the glass lid as a working surface.
1. Never fill chip pans more than one third full with oil or fat.
2. Never leave oil or fat unattended during the heating or
cooling period.
3. Never heat fat or fry with a lid on the pan.
4. Always dry food thoroughly before frying, and lower it
slowly into the hot oil or fat. Frozen foods in particular will
cause frothing and spitting if added too quickly.
5. Always keep the outside of the pan clean and free from
streaks of oil or fat.
1. Do not move the pan.
2. Turn off the hotplate burners.
3. Smother the flames with a fire blanket or damp cloth to
extinguish the fire.
Do not use water or a fire extinguisher as the force of it may
spread the burning fat or oil over the edge of the pan.
4. Leave the pan for at least 60 minutes before moving it.
In the event of the burner flames being accidentally extinguished,
turn off the burner control and do not attempt to re-ignite the
Burner for at least one minute.
and the small flame symbol
. Press the
for