Belling 152 Installation And User Instruction Manual page 9

The cooker is designed to match the depth of
standard 600mm worktops. An adaptor backplate
should, therefore, be fitted within the 160 x
250mm shaded area shown, pointing towards the
left to allow the cooker to be pushed fully to the
wall. If a forward facing backplate is used, it must
be chased into the wall.
This area to be
clear of pipework
and obstructions
Electrical
Connection
Connection to the cooker should be made with an approved appliance flexible connection
to BS 669. A length of 0.9 to 1.25m is recommended. The length of hose chosen should
be such that when the cooker is in situ, the hose does not touch the floor.
LPG models should be connected with a hose suitable for LPG and capable of withstanding
pressure of 50 mbar.
The temperature rise of areas at the rear of the cooker that are likely to come in contact
with the flexible hose do not exceed 70˚C.
After installation, check for soundness.
The supply pressure is tested at the hob burner.
With reference to the user's instructions:
1. Check that the hotplate burners ignite correctly and burn with a steady flame.
2. Check for a steady flame at the low (small flame symbol) setting.
3. Instruct the user on the operation of the cooker.
Connecting to the Gas Supply
Mains Inlet on Appliance
160
75
570
1090
60
9