Table of Contents
Advertisement
5. Maintenance
(4) 50 h
100 Nm
1 Stop buffer
2 Lock nut for stop buffer
3 Adjustment nut for steering handle central
mounting
4 Lock nut
5 Fastening nut for steering handle
agria Tool Carrier 5500 Grizzly
Grizzly premium
Steering Handle Central Mounting
Re-tighten adjustment nut (3) with 100
Nm after the first 4 operating hours, then
after every 50 operating hours.
Remove pin retention to unscrew fas-
tening nut for steering handle (5).
Remove steering handle and place
aside.
Loosen lock nut (4).
Tighten adjustment nut (3) with 100
Nm.
Re-tighten lock nut (4) (lock).
Mount steering handle. Brush some
lubrication grease onto gliding faces, if
necessary.
Screw on fastening nut (5) until steer-
ing handle is without play but can still
be swivelled. Secure with pin.
Steering Handle Pendulum Stop
This 2-axle-steering handle bearing
provides optimum dampening when
each of the two stop buffers is adjusted
to a play of A = 0.5 mm (in position zero,
with no load on steering handle) to the
stop plate.
Adjustment:
Loosen hexagonal nuts (2).
Adjust stop buffer (1) by turning it to
the above stated play.
Re-tighten hexagonal nut (lock).
5
45
Advertisement
Table of Contents
