Wiring The Fiber Optic Model - Bosch VG5 600 Series Installation Manual

AutoDome 600 Series Analog PTZ Camera
3.4.3

Wiring the Fiber Optic Model

1.
2.
NOTICE!
You will need a barrel connector (not supplied) to connect the BNC connector from the Pipe
Interface Board coax cable to the Fiber Optic Module BNC connector.
3.
Bosch Security Systems, Inc.
If installing a Fiber Optic model, bring the fiber optic cable into the right side of the
power supply box.
If installing a Fiber Optic model attach the incoming ST fiber plug, installed previously, to
its mating connector on the Fiber Optic Module in the power supply box. Refer to
Section 5 Cable and Wire Standards, page 67 for fiber optic specifications.
Route the control wires from the Power Supply to the Pipe Interface Board. Then attach
the supplied six (6) pin control data connector to the wires in the Power Supply Box.
(GND)
24V NC 24V
GND TXD RXD
1 Transformer
2 BNC to Dome
3 In/Out
4 From Arm Harness
Installation Manual
Installing the Roof Parapet and Pipe Mounts | en
C+ C-
5 In/Out
6 ST Connector (Fiber)
7 Power In
8 Data In/Out
43
F.01U.265.793 | 2.0 | 2012.02